![]() It doesn’t make sense for your magic mirror to just display the Raspberry Pi desktop, and fortunately, there are a few ways to get your Raspberry Pi to work like a kiosk. Once you’re through the NOOBS installation process, you’ll be rewarded with the Raspberry Pi boot sequence. ![]() Next, if you already hadn’t, you’d have to install Raspbian, the Raspberry Pi Foundation’s official operating system. Simply hook up the Raspberry Pi to the monitor, and Ethernet to the router. The point of this is to supply power to both the monitor and the Raspberry Pi with a single cable. Then all of the components can nicely fit together on the back of the monitor, with the help of some industrial tape, as pictured below. The easiest way to do this is to buy a two-way power splitter. Ideally you’d want to have just one cord coming out of the bottom of the case to supply power. Afterwards, gluing everything together is all there is to it. To avoid a hassle, be sure to stain the frame and case separately before gluing the mirror between them. You should also make one of the holes at the bottom of the case large enough for a power plug to fit through, since you’ll need it when you’re wiring your monitor and Raspberry Pi’s power through the case. By doing this, you’ll be able to remove the monitor without any issues.Īn important tip here is to screw holes at the top and bottom of the case, giving the Raspberry Pi some airflow. This part is basically all about cutting your pieces to fit the monitor into the case. ![]() Build the caseīuilding the case doesn’t require much work. Be sure to order a mirror that’s close in size to your monitor so you can build with ease. It’s simple (and safer) to cut it in several different ways to make it fit the way you need. Otherwise, it could be difficult to fit the frame, and the Raspberry Pi’s HDMI cord must also fit.īeing the most essential piece of the whole project, the mirror, being acrylic and plastic-like, is easier to work with compared to an actual mirror. One important aspect is to make sure you get a monitor with the inputs located towards the center of the monitor rather than on the sides. When it comes to the size of the mirror, it depends on the kind of monitor you select.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |